Multiple TSTALM: Module 1,01,02 Block 1001 is tested multiple times (mode 2)
When multiple TSTALM blocks test the same block, it usually indicates an error in cloning the logic. If this is the case then a block that is intended to be tested will have been missed.
Specifically, Spec S1 is can be missed when the block numbers are changed in copied logic.
Multiple TSTALM: Module 1,27,02 Block 21160 is tested multiple times (mode 2) Module 6,70,03 Block 1529 is tested by multiple TSTALM blocks (mode 2).
This message is likely to show an error in the system configuration. It should be reviewed. The issue raised may be in unused logic or graphics, or have other realities that make it a non-issue.
Please contact us for help resolving your error messages.
DBDOC ©1996 - 2019 G. Michaels Consulting Ltd., all rights reserved. All other trademarks and registered trademarks are the property of their respective holders. Website source largely available under the terms of the AGPLv3.