Loop 261 out of range (0-250) for Module 1,01,02 Block 1234 (FC 37)
This message means that the value of the loop is smaller or larger than the allowed value range.
It is possible that a spec has been entered incorrectly.
Loop must be between 0-250.
This message is likely to show an error in the system configuration. It should be reviewed. The issue raised may be in unused logic or graphics, or have other realities that make it a non-issue.
Please contact us for help resolving your error messages.
DBDOC ©1996 - 2022 G. Michaels Consulting Ltd., all rights reserved. All other trademarks and registered trademarks are the property of their respective holders. Website source largely available under the terms of the AGPLv3.