PID Controller Module 4,14,03 Block 4222 has primary gain spec S12 zero
A controller has its overall gain spec set to zero, which will force the output to be 0.0 unless it is tracking.
The effect of either of the above sets of conditions is that the output is 0.00.
Note that the output is not 0.0 under the following conditions for FC 156 (APID).
The image shows live data when tracking is switched on.
This message is likely to show an error in the system configuration. It should be reviewed. The issue raised may be in unused logic or graphics, or have other realities that make it a non-issue.
Please contact us for help resolving your error messages.
DBDOC ©1996 - 2021 G. Michaels Consulting Ltd., all rights reserved. All other trademarks and registered trademarks are the property of their respective holders. Website source largely available under the terms of the AGPLv3.