REMSET limits out of order: Module 1,40,31 Block 24520 S3 low limit 1.0 greater than S2 high limit value 20.0 (adapted)
This message means that the REMSET: Remote Manual Set Constant [FC68] block has an S3 low limit greater than the S2 high limit value.
This may indicate a problem.
In the image below, the S3 value greater than an S2 value. Because of this, the range of acceptable values does not exist.
This block allows an operator to enter a constant to the control scheme. S2 and S3 are the limits of the range of values the operator can enter.
This message is likely to show an error in the system configuration. It should be reviewed. The issue raised may be in unused logic or graphics, or have other realities that make it a non-issue.
Please contact us for help resolving your error messages.